Location :  Home  >  Products  > Detailed Information : PCL Series Vertical Shaft Impact Crusher(Sand Making Machine)

PCL Series Vertical Shaft Impact Crusher(Sand Making Machine)

Tiger Crusher High Efficient PCL Series Vertical Shaft Impact Crusher(Sand Making Machine)

PCL Series Vertical Shaft Impact Crusher(Sand Making Machine) is developed on the basis of the introduction of similar products of advanced technology from Germany. The equipment is high energy low consumption achieving international advanced level. The discharging granularity is fine and even (3 mm to 8 mm). And parts durability is strong with less wearing parts. Its maintenance is convenient. Compared with the traditional crusher, the equipment is low energy consumption and large production capacity (30-130 t/h). The performance plays an irreplaceable role in all kinds of ores fine crushing equipment. The equipment is currently the most effective, practical and reliable. This equipment is widely used in metal and non-metallic ores, cement, refractory, bauxite, silicon carbide, building materials, artificial sand fine crushing, especially on the medium hard and super hard material.

Model: PCL Series Vertical Shaft Impact Crusher(Sand Making Machine)

Quality Certification: CE & ISO9001

Mesh Size Of Feed: ≤ 60 mm

Production Capacity: 20-380 T/h

Applicable Materials: pebble, calcite, granite, quartz, concrete, dolomite, bluestone, iron ore, limestone, construction waste, etc.

Features & Characteristics:

1. Deep cavity type rotor after optimization design, through material quantity increases by about 30%.

2. High sand-making ratio; good size and shape.

3. With functions of finely, coarse grinding.

4. Week guard can use back up and down after partial wear, improve material utilization, can improve the service life 48% longer.

5. Little affected by the material moisture content; water content up to 8% is available.

6. “Stone hit stone”, “stone hit the iron” easy conversion; high efficiency and energy saving, high crushing ratio.

7. Cube structure, high bulk density, and small iron contamination.

8. Less wear of impeller from the lining, easy maintenance.

9. Low wearing parts consumption – design of the best material impact angle of crushing cavity. Less friction between wear parts, 30% lower than conventional equipment running cost.

Operating Principle:

Material from the hopper into the body, the distributor will material is divided into two parts, part from the distributor in the middle to high speed rotating impeller chamber, within the impeller was accelerated rapidly, its acceleration can be up to several hundred times the gravitational acceleration, and then at the speed of 60-70 - m/s from three uniform mass ejection of the flow passage of impeller to go out, the other part of the distributor all around, and then hit with vortex cavity lining material and be lining material rebound, oblique upward shocks to the top of the vortex chamber, and change the direction of movement, deflecting downward movement, emitted from the impeller passage of material to form a continuous material. Such a piece of material is impacted, grinded and crushed twice or more in the vortex broken cavity. The grinding materials discharge from the bottom discharging opening. In the process, materials impacting and rubbing with lining crush finely with each other without direct contact with metal components. So the iron pollution reduces and mechanical wear prolonged. Ingenious self circulation in the vortex chamber makes no powder pollution.